Saltar al contenido principal

Connecting to a Cluster

See Renec Clusters for general information about the available clusters.

Configure the command-line tool#

You can check what cluster the Renec command-line tool (CLI) is currently targeting by running the following command:

renec config get

Use renec config set command to target a particular cluster. After setting a cluster target, any future subcommands will send/receive information from that cluster.

For example to target the Testnet cluster, run:

renec config set --url https://api-testnet.renec.foundation:8899

Ensure Versions Match#

Though not strictly necessary, the CLI will generally work best when its version matches the software version running on the cluster. To get the locally-installed CLI version, run:

renec --version

To get the cluster version, run:

renec cluster-version

Ensure the local CLI version is greater than or equal to the cluster version.